Best Guide For Attic Hatch Cover
Attic hatch cover – The conversion of an attic into the living space requires detailed planning. You will need to examine structural support before you actually start working. Do not assume that house beams or walls will absorb the added weight of an attic conversion. Be sure to consult with experts before work begins. By figuring out the details of any structural challenges ahead of time, you can go ahead with a plan to build a beautiful space. Interesting features, such as sloping ceilings, a large skylight or attic deck space should make the finished project very attractive.
An attic flap is something that can be add to the inside of your home to give you better access to your attic space. The floodgate can also be refer to as a penthouse scuttle hole. And the whole installation process should not last more than a few hours. The location of the attic gate is usually inside a closet in your home or in a hallway. However, if you choose a place closet, then the cutout of the attic hatch cover will be more hidden.
22 Photos Gallery of: Best Guide For Attic Hatch Cover
Measure the space on the roof where you want the hatch that is carefully locate. Use a pencil and tape measure to track a rectangular piece that can be remove to create the hatch. Make sure it is large enough for you to access the space. Put on goggles and a face mask. Then use a saw to cut around the rectangle to track. Keep your cut clean. Because you need the part cut to complete the hatch. Remove the piece and keep it in reserve. Then install a frame around the entire hole then cut. The adjustment should be wide enough to support the roof piece that closes the hatch.
Add weather stripping all the way around the molding to help insulate the hatch. Weather-strip can add on the outside of the piece to be cut from the ceiling as well. Cut a piece of rigid insulation coating that is one inch smaller all the way around the roof piece you remove from the attic hatch cover. Attach the roofing to the attic side of the roof piece with construction adhesive. Use the construction adhesive to add a layer of battery insulation for the coating. Turn the roof part on its side and insert it into the roof hole. Put it face up and place it on the top of the molding you installed to complete the hatch.