How to Install Outdoor Lighting – Place a separate circuit for outdoor lighting lets you isolate it from the rest of the house. Outdoor lighting is essential for dark areas and also provides illumination at night. Turn the tote located in the fuse box. Slide the cable from where the lighting system will be installed through the outer wall, which must drill a large enough hole to pass how to install outdoor lighting.
13 Picture Gallery: How to Install an Outdoor Lighting Circuit
How to Install Outdoor Lighting
Also you must drill a hole in the basement space or drag on the floor that slides into the wall. Place the cable in the wall in which the switch is located and cut the cable to length. Slide another cable from where wills the switch to the basement or crawl through the hole.
Slide the cable along the joists in the basement, routing the wire to the connectors with their respective supports. Place the cable in the wall that has your main fuse box. Remove the cover of your fuse box by loosening the screws from around the panel. Do not touch anything that is above the main switch as being energized, can cause injury or even death. Sliding the cable to the fuse through the hole located on the housing of the same.
Install the new circuit using a space in the fuse box is important when you deciding on how to install outdoor lighting. In this area you can find several of them, with which you can press or directly by pressing the fuse or can push from the other side to attach it to its position. Remove about 1 “(2.5 cm) from each end of the new cable circuit. Connect the black wire to the fuse box by sliding the bracket screw and screw firmly. Fix the white wire and the ground wire to metal bar located within the switch, sliding on the screw. Replace the cover of the switch box.
Return to your switch. Remove back 1 “(2.5 cm) of insulation from the ends of the wires and connect its cable, connecting the two black wires to the screws on this. Splice the two ends of the white wire and screw the ground wires to green screw on the metal switch box and then connect it to the junction box. Attach the lid screwing. Turn the switch and test your installation to complete the activity when you have done and no more question of how to install outdoor lighting.
This post topic: Outdoor Lighting