How to Repair the Motion Detection Lights Sensor

Jun 30th
Outdoor Light Sensing Switch
Outdoor Light Sensing Switch

External lights with detection lights sensor providing enhanced security to your home, but as they are subject to the weather throughout the year, with time could develop some problems that need to be addressed to maintain their profits. Repair these devices is not as difficult as the number of potential problems that can make the repair does not work. Knowing what steps to take will help you get through the light problem in less than an hour from detection lights sensor.

11 Picture Gallery: How to Repair the Motion Detection Lights Sensor

Turn the key thermal energy leading light with motion sensor. Leave it off for about 30 minutes and then turn it back on. Check the light to see if the lamps are on. If they are, the sensor just needed to be restored and the light off in seconds. This step will reset the sensor and can be used to set one lamp that was stuck in the on position or a light that will not turn on at all. If a reboot does not solve the problem, continue to the next step.

Replace lamps with new ones. A climate aggressive or rapid temperature changes can cause the lamps have a short life. If the devices use incandescent lamps, it can be tested in an ordinary lamp before buying replacement lamps. Also check if the lamp has broken filaments signs to help you determine if it is in poor condition. Adjust the features in the bottom of the motion sensor. Someone may have tried to change them at some point and may require a reconfiguration with the desired settings.

Set the direction of the sensor to point to the right direction. Over time, wind or fallen branches could cause the sensor to change its angle making it not work as intended. While doing the settings, check the sensor lens looking any accumulated dirt and clean it with a soft cloth if necessary.

Advanced repair outside lights with motion sensor

Turn off heat that feeds the key external light with detection lights sensor. Remove the screws that secure the lamp housing to the wall box. Try the wires inside touch with a voltmeter before touching any of the wires. Press the button on the meter and Toes him each of the wires to make sure there is no current in the circuit. If the meters beep or lights, that means the circuit continues on. Try the other keys until you find the proper heat.

Disconnect the black and red wires from the back of the circuit motion sensor. Then connect the black wire from the light fixture to the black wire directly feed into the box. Secure the connection with a wire connector. The key back is on heat. Check out the shop to see if the lamps are on. If they are, the motion sensor is broken and must be replaced. If the lights are not on, check the wiring again and if the lights are on or not. If everything looks good and does not work, the applet of the light with detection lights sensor itself is broken and must be replaced.

This post topic: Outdoor Lighting

Other Interesting Things About Outdoor Lighting Photos