Recessed lights are a lighting device one of modern ceiling light fixtures that can be inserted into any ceiling in any room of a house. This will take no more than about 2 hours from start to finish, and there are few tools and knowledge needed. While it is always best to use a licensed electrician for any electrical work from modern ceiling light fixtures, this is a job you can do easily and without help.
Measure the outer circumference of the lights so you know how much of the roof must cut to fit the lights. Mark on the roof the exact location and contour of the lights so you can cut the area with the saw. Cut these areas. Lights connected in series, so that a cable enters and leaves the next and goes to the next light. Remember that green wires green wires are connected, the red to red and white wires to white wires. To do this, use the pliers to cut the wires and then join them. To bring the modern ceiling light fixtures and wires together, pass the cable through the clamp that comes with the lights and tighten the clamp with the clamp.
Connect the red wire from the ceiling to the red wire from the first light with wire nuts. Connect the green wire from the ceiling to the green wire at the first light. Do the same with the white wire and the black wire to ground. Connect the other red wire from the first light to the red wire of the second light.
Continue to do this for all other cables from the first light to the second light and the second light to the third and so on. Set the unit on the roof, putting the cover plate and sliding the unit on the roof. Press the four locking tabs to lock the light hole to not fall, as no screws for inserting or any other form of securing them. Embed the modern ceiling light fixtures frame.
10 Picture Gallery: Modern Ceiling Light Fixtures for Your Brand New Kitchen
This post topic: Ceiling Lighting