Installing Skylight Shade
Skylight shade – Ceiling windows are good for adding light to dark rooms and cutting down on the use of electricity from lamps. But skylights can also allow heat to escape from a home or allow cold air i. The most effective way to make skylights make is to replace them with skylights that have double-glazed glass and several layers of insulating glaze. If you do not want to replace your skylight, consider adding a skylight shade that helps to reduce energy losses.
Select a skylight shade for your existing skylight by visiting your local window shop or home improvement retailer. Skylight shades are usually made of multiple layers of pleated fabric that contain a lot of air between the shade and skylights, creating a layer of insulation that prevents heat transfer through the skylight.
25 Photos Gallery of: Installing Skylight Shade
Select a motorized skylight so you can easily adjust the level of light in a room, close the skylight at night or reduce the amount of hot or cold air entering the room. Set a professional skylight technician to install the shadow. If done incorrectly, you may lose your warranty. Ask your local window shop or home improvement retailer about installation options and costs.
Skylight shade is used to help bring light into rooms in homes where the sun does not shine so much. There are many different types of skylight shade, including solid and venting. Whether they are open or not, installation on them will be the same. Finding the right place to install your skylight shade is the first and most important step in the installation process.
Inspect the roof to determine where the skylight shade will be installed and measure the size of the skylights. Enter and find a place where every edge of the skylight will be lined by the ceiling beam. Hammer a nail in each corner from the inside so that they can be found on the roof. Select a square with a chalk line on the ceiling to indicate where the light will be installed. Remove all shingles and the base with a single stripper. Cut out the opening with a circular saw. Cut carefully to see the correct cut.
Cut a 2-by-4 to the size of the width of the opening and screw over the top of the opening. Repeat the process for the bottom to allow the roof window a header to install on. Set the skylights in the opening and screw it into place by tightening it to the head that was installed, placing a screw every six inches around the entire circumference. Roll flashing around the perimeter of skylight and nail it into place with roofing nails. Inspect the area to make sure everything is properly sealed and any gaps or cracks are visible.