Stainless Steel Chimney – Stainless steel fireplaces or fireplaces are commonly installed to vent wood-burning stoves. Use only class “A” insulation fireplaces stainless steel double or triple wall and Underwriters Laboratories or UL, approved. Double-walled stainless steel fireplaces have two layers and triple-wall fireplaces have three layers. The extra layers that the exterior of the chimney chiller, decreasing the risk of fire damage and heat materials surrounding. Installing a fireplace can make that dream fireplace or wood burning stove a possibility. This is not only good for aesthetics. You can improve the resale value of your home, and a fireplace or wood stove can reduce heating expenses in the winter.

Chimney installation requires taking steps to avoid danger in the home. Install a fireplace by placing a new wood stove on the home page or installing a fireplace. A stainless steel chimney is needed for smoke siphon and house ashes. Must be a stone masonry fireplace or approved UL insulated stainless steel fireplace with an “A” rating. Install the stainless steel fireplace with suitable flashing to seal against rain and elements. This will prevent leaks and smoke that enters the home page. Also, install it so that it reaches at least 5 feet from the top of the roof. The chimney will also need to be supported so that wind or snow does not make the curve. You should also install a chimney cap to prevent small animals from climbing into the fireplace when not in use and to prevent rain flooding.

A support will also need to be installed inside the house to keep the roof from collapsing where the fireplace is installed. If the fireplace goes through an attic, a radiation shield is needed to keep the heat from setting fire insulation. The roof will also need a radiation shield. A stainless steel chimney cap may be just the ticket if you want to keep water from entering the chimney, which can cause damage to your chimney and combustion chamber. A chimney cap also prevents birds and other animals from entering the flue.

Chimney caps also prevent descending air currents and can be used in smoke tubes that are used to expel smoke from burning wood, charcoal, gas or oil. Some chimney tops may also have a screen installed to keep wood embers from fires landing on their roof or surrounding vegetation. The stainless steel chimney lid should be tightly fitted to the chimney to prevent the wind from blowing. Push the chimney flap over the chimney flue until it is fully seated. Attach a chimney cap strap around the base of the lid legs.